[...]

Hit any key to stop autoboot:  0
Setting bus to 6
_find_partition_by_name()-200: do not find match in table boot
_find_partition_by_name()-200: do not find match in table boot
error partition name!
4096 bytes read in 1 ms (3.9 MiB/s)
_find_partition_by_name()-200: do not find match in table boot
_find_partition_by_name()-200: do not find match in table boot
error partition name!
4194304 bytes read in 2 ms (2 GiB/s)
avb2: 1
active_slot is normal
ab_suffix is
_find_partition_by_name()-200: do not find match in table vbmeta
_find_partition_by_name()-200: do not find match in table vbmeta
get partition info failed !!
_find_partition_by_name()-200: do not find match in table vbmeta
_find_partition_by_name()-200: do not find match in table vbmeta
error partition name!
Failed to read 65536B from part[vbmeta] at 0
avb_slot_verify.c:721: ERROR: vbmeta: Error loading vbmeta data.
avb verification: locked = 1, result = 2
try upgrade as booting failure
PHY2=00000000fe03a020,phy-base=0xfe03e000
noSof
Device: emmc
Manufacturer ID: 15
OEM: 100
Name: BJTD4
Bus Speed: 192000000
Mode : HS200 (200MHz)
Rd Block Len: 512
MMC version 5.1
High Capacity: Yes
Capacity: 29.1 GiB
Bus Width: 8-bit
Erase Group Size: 512 KiB
HC WP Group Size: 8 MiB
User Capacity: 29.1 GiB WRREL
Boot Capacity: 4 MiB ENH
RPMB Capacity: 4 MiB ENH
card in
** Unrecognized filesystem type **
** Unrecognized filesystem type **
starting USB...
USB0:   Register 1000120 NbrPorts 1
Starting the controller
USB XHCI 1.10
USB1:   No ----gpio-vbus-power
Register 2000120 NbrPorts 1
Starting the controller
USB XHCI 1.10
scanning bus 0 for devices... 1 USB Device(s) found
scanning bus 1 for devices... 2 USB Device(s) found
       scanning usb for storage devices... 0 Storage Device(s) found
active_slot: normal
_find_partition_by_name()-200: do not find match in table recovery
_find_partition_by_name()-200: do not find match in table recovery
error partition name!
Err imgread(L199):Fail to read 0x2000B from part[recovery] at offset 0
Err imgread(L466):Fail read dtb from recovery, ret 200
restore dtb
the dtb partition size is:40000   byte
_verify_dtb_checksum()-2815: calc 0, store 0
update_dtb_info()-2923: cpy 1 is not valid
_verify_dtb_checksum()-2815: calc 0, store 0
update_dtb_info()-2923: cpy 0 is not valid
dtb_read()-3030: total valid 0
Err imgread(L339):Fail read dtb from rsv with sz 0x40000
Err imgread(L466):Fail read dtb from _aml_dtb, ret -340
[imgread]read from part: recovery
_find_partition_by_name()-200: do not find match in table recovery
_find_partition_by_name()-200: do not find match in table recovery
error partition name!
Err imgread(L545):Fail to read 0x100000B from part[recovery] at offset 0
kvim4#