OrangePI win plus GPIO out not working

hello Armbians,

Since over an year I try to use this useless Board.

Now i  want too switch 3 Relays modules with the gpio system, after an udp command.

I installed Wiring pi , 

gpio  readall work

gpio write 25 1 , works to  the inputt get the value 1

gpio mode 25 out, does not work

echo 36 > /sys/class/gpio/export
echo out > /sys/class/gpio/gpio36/direction

echo 101 > /sys/class/gpio/export
echo out > /sys/class/gpio/gpio101/direction

the input is without an error but with gpio readall nothing changes

this code I wrote to use the gpio with python

export38= open('/sys/class/gpio/export','w')
export38.write('38') 
export38.close()
	
active_low38= open('/sys/class//gpio/gpio38/active_low','w')
active_low38.write('1') 
active_low38.close()

direction38= open('/sys/class//gpio/gpio38/direction','w')
direction38.write('out') 
direction38.close()


value38= open('/sys/class//gpio/gpio38/value','w')
value38.write('1') 
value38.close()

but also with gpio readall nothing changes.

this code work on an rpi3 

export26= open('/sys/class/gpio/export','w')
export26.write('26') 
export26.close()
	
active_low26= open('/sys/class//gpio/gpio26/active_low','w')
active_low26.write('1') 
active_low26.close()

direction26= open('/sys/class//gpio/gpio26/direction','w')
direction26.write('out') 
direction26.close()


value26= open('/sys/class//gpio/gpio26/value','w')
value26.write('1') 
value26.close()

with gpio the pin 37 changes to high.

on the opiwin the values in the filesystem changes but not with gpio readall

does somebody else have this problems?

does the gpio system not work or wiring pi?