Install arduino on Nano pi m4 and asus thinkerboard with os armbian and arduino uno wifi rev2 board connected to USB

Arduino allways complains with : 

avrdude : usbdev_open() : cannot open device : Permission denied 

avrdude : jtag3_open_common() : Did not find any device matching VID 0x03eb  and PID list : 0x2145

 

Nevertheless I belong to group dialout and permissions on /dev/ttyACM0 are crw-rw----

Tried everything what was explained on internet about the topic but without any result !!

The same issue on the ASUS Thinkerboard !!

When I do "Get board info" then arduino detect the board correct !! ( BN:Arduino Uno Wifi Rev2 , VID:0x03eb,PID:0x2145,SN:56008C7BBC944... ) 

Permission

https://playground.arduino.cc/Linux/All/#Permission

groups oder id listet meine aktuelle Zugehörigkeit

less /etc/group | dialout

 

usermod -a -G group-name username

usermod -a -G dialout tido

 

sudo chmod a+rw /dev/ttyACM0

 

---

or you try

 

PlatformIO

Nicht vergessen: Nach-Hause-telefonieren abschalten

platformio settings set enable_telemetry no

platformio settings set enable_ssl yes

Thanks for reply but unfortunately , have done all this stuff and it does not work !!

usermod -a -G group-name username

usermod -a -G dialout tido

 

sudo chmod a+rw /dev/ttyACM0

 

 

This is the red text in arduino ide:

 

avrdude: Version 6.3-20190619
         Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/
         Copyright (c) 2007-2014 Joerg Wunsch

         System wide configuration file is "/home/marc/.arduino15/packages/arduino/tools/avrdude/6.3.0-arduino17/etc/avrdude.conf"
         User configuration file is "/home/marc/.avrduderc"

         Using Port                    : usb
         Using Programmer              : xplainedmini_updi
         Overriding Baud Rate          : 115200
avrdude: usbdev_open(): cannot open device: Permission denied
avrdude: jtag3_open_common(): Did not find any device matching VID 0x03eb and PID list: 0x2145

avrdude done.  Thank you.

An error occurred while uploading the sketch

try

/etc/udev/rules.d/99-tty-dialout.rules

SUBSYSTEM=="tty", KERNEL=="ttyUSB0", GROUP="dialout", MODE="0666"
or

/etc/udev/rules.d/99-instruments.rules       //new file
SUBSYSTEM=="tty", GROUP="dialout", MODE="0666"

 

or like my i2c

/lib/udev/rules.d/60-i2c-tools.rules
SUBSYSTEM=="i2c-dev",KERNEL=="i2c-[0-9]*", GROUP="i2c", MODE="0660"   //replace "0666"