Hi forum members,
since I'm playing with the use of onewire sensos, I came up with the question to use more than one GPIO-pin for the onewire protocol.

 

Is it possible to configure multiple GPIO-pins that the output of: cat /sys/kernel/debug/gpio shows more than one onewire gpio pin ?

If YES, how can I find the connected sensors under the /sys/bus/ structure?

 

Tanks in advance
wollik

 

 

 

 

Your issue report is not a valid bug report per the Armbian bug reporting instructions (https://www.armbian.com/bugs).  With limited resources the Armbian project is only able to spend time on issues where all the requested information has been provided and for only the boards/images/software that are supported.  Your report is invalid for one or more of the following reasons (non-exhaustive list):

 

• it is for an unsupported board or image (CSC/EOS/WIP/edge)
• it is for software that is not supported (such as userspace modules installed on top of the core operating system)
• it has been logged in the wrong forum (for example requests for help that are not actual bug reports)
• it lacks requested data (armbianmonitor output)
• it could have been easily solved by a quick search and/or reading documentation

 

Please review what you have submitted and the bug logging instructions (https://www.armbian.com/bugs) and either add the required information or open a new topic in the correct forum (such as P2P Help or Off-Topic)

Hi Werner,
this was not a bug report, it was just a question to the forum members if someone have an idea.
Here is the forgotten link to my armbian details: http://ix.io/3HK8 that will not show any bug!

 

If this was the wrong forum, please where/in what forum should this kind of general Allwinner H2 & H3 questions have been asked?

Regards
wollik

As suggested by the bug reporting form which you were asked to fill in before opening topics in this forums and you probably ignored that it would have told you to state this kind of question in the P2P Help:https://forum.armbian.com/forum/25-p2p-help/

Hi forum admin(s)
please can you move this topic to the correct P2p section?

 

Regards
Wolfgang

Moved to Common issues / peer to peer technical support