7 minutes ago, 张军 said:

I did several tests and the problem was fixed after using the above device tree. But there seem to be some problems with the U-Boot.

Thanks for confirming I will raise a PR for this.

 

7 minutes ago, 张军 said:

I used an SD card to boot and often the card would not move after the above print after reboot, it seems that the identified DRAM capacity is wrong.

Yes, modern u-boot detects the frequency sometimes wrong. I added a fix for this that reduced the frequency of the issue. Previously in my tests it was happening 50-80% of times on reboot. After integrating the fix the issue seems to have gone down to like 1 in 10 times or so. I will try to further tweak the fix and see if I can make it non-existent.

On 9/23/2023 at 8:52 PM, 张军 said:

U-Boot SPL 2023.07.02-armbian (Sep 19 2023 - 18:28:54 +0000)
DRAM: 4096 MiB
Trying to boot from MMC1

I used an SD card to boot and often the card would not move after the above print after reboot, it seems that the identified DRAM capacity is wrong.

This is now fixed. Updated u-boot should be available in beta repository within 24 hours.

@aoleynik

Were you able to figutre out the issue?

 

I think this might be your post also - http://www.orangepi.org/orangepibbsen/forum.php?mod=viewthread&tid=148411&page=1&authorid=4503426

 

If so, the error you describes mine perfectly. I have been banging my head on this for a  week. 

 

Thanks

@sliverb, this thread is about the software issue that was fixed.
 

The post you mention is mine and I think it's about a hardware issue. I have sent the board to the seller for testing and repair.

Thanks 

@aoleynik

 

I wasnt sure if it was hadware related, though i suspected as much. Thanks for confirming. When i read your post, it matched the issues i saw 100%. (Part of me was hoping it was software related).

 

I'll reach out to the seller to see if they are open to helping me out.

 

Again, I appreciate your help on this.