Hi all,

 

I need a help. I installed the armbian Debian Jessie 4.9.5 in my cubietruck. It is connected via HDMI. How do I set the output of sound to be HDMI?

 

Thanks and best regards

https://forum.armbian.com/index.php/topic/397-mainline-a10a20-audio-driver/?p=24186

Hi Igor,

 

If I used armbian legacy 3.4.113. Would it be easier to change audio output to HDMI?

Yes, HDMI audio works out of the box on legacy / 3.4.113

Hi Igor,

 

With armbian Debian 3.4.113 the cubietruck wifi not work but with mainline 4.9.5 it´s works. Is there any configuration for it to work in 3.4.113?

 

# iwconfig wlan0

wlan0     IEEE 802.11   Acess Point: Not-Associated

               Link Quality:0    Signal level:0   Noise level:0

               RX invalid nwid:0   invalid crypt:0   invalid misc:0

 

Do I need to load any modules?

 

I tried:

 

# modprobe bcmhd

Modprobe FATAL: Module bcmhd not found.

 

Thanks 

We don't use that module since some time ... ap6211 and check if firmware is in place and loaded. In any case, logs would drastically help to see what's wrong 

armbianmonitor -u

Hi Igor,

 

Thanks for your help!

 

http://sprunge.us/DPeQ

 

Ah! Reboot and shutdown cause kernel panic in 3.4.113. I remember that with the 3.4.112 kernel this did not happen.

Driver should be ap6210 ... sorry.

Check my bootlog. Wifi is working fine 

http://sprunge.us/Beed

 

root@cubietruck:~# iwconfig wlan0
wlan0     IEEE 802.11  ESSID:"XXXXX"  
          Mode:Master  Frequency:2.427 GHz  Access Point: XX:XX:XX:XX:XX:XX   
          Bit Rate=65 Mb/s   Tx-Power:32 dBm   
          Retry min limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off

 

Driver should be ap6210 ... sorry.

Check my bootlog. Wifi is working fine 

http://sprunge.us/Beed

 

root@cubietruck:~# iwconfig wlan0
wlan0     IEEE 802.11  ESSID:"XXXXX"  
          Mode:Master  Frequency:2.427 GHz  Access Point: XX:XX:XX:XX:XX:XX   
          Bit Rate=65 Mb/s   Tx-Power:32 dBm   
          Retry min limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off

 

Very strange. Can it be the cubietruck review?

I can not see the review of my cubietruck because it already came with the heatsink on the processor.

When I use mainline version 4.9.5, the wifi works correctly.

 

I am trying to connect cubietruck as a client of my routerboard.

 

I'll try some more tests here.

 

Anyway thanks for the help Igor.