hostapd no internet on BPI M2 Plus

I have armbian 5.65 ( kernel 4.14.78-sunxi) on BPI M2 Plus

I can enable hotspot using armbian-config but when connect to AP, no internet access

Is there any setting missing here??

/etc/network/interfaces

# Network is managed by Network manager
auto lo
iface lo inet loopback
pre-up ifconfig eth0 hw ether 22:33:44:55:66:77

/etc/network/interfaces.d/armbian.ap.nat

# armbian NAT hostapd
allow-hotplug wlan0
iface wlan0 inet static
        address 172.24.1.1
        netmask 255.255.255.0
        network 172.24.1.0
        broadcast 172.24.1.255

/etc/hostapd.conf

#
# armbian hostapd configuration example
#
# nl80211 mode
#

ssid=ARMBIAN
interface=wlan0
hw_mode=g
channel=5
#bridge=br0
driver=nl80211

logger_syslog=0
logger_syslog_level=0
wmm_enabled=1
wpa=2
preamble=1

wpa_psk=xxxxxxxxxxxxxx
wpa_passphrase=xxxxxxx
wpa_key_mgmt=WPA-PSK
wpa_pairwise=TKIP
rsn_pairwise=CCMP
auth_algs=1
macaddr_acl=0

noscan=1

## IEEE 802.11n
ieee80211n=1
ht_capab=[DSSS_CK-40][HT20+]
country_code=US
ieee80211d=1
## IEEE 802.11n

### IEEE 802.11a
#hw_mode=a
### IEEE 802.11a

### IEEE 802.11ac
#ieee80211ac=1
#vht_capab=[MAX-MPDU-11454][SHORT-GI-80][TX-STBC-2BY1][RX-STBC-1][MAX-A-MPDU-LEN-EXP3]
#vht_oper_chwidth=1
#vht_oper_centr_freq_seg0_idx=42
### IEEE 802.11ac

# controlling enabled
ctrl_interface=/var/run/hostapd