greg798

Hi. Im used OPi3 and img to OPI3 Minimal/IOT images with Armbian Linux v6.6 https://www.armbian.com/orange-pi-3/

Hi. I'm having network problems at last armbian (Armbian_community_24.11.0-trunk.130_Orangepi3_bookworm_current_6.6.44_minimal). Link drops ethernet RTL8211E all the time and sometimes board won't come out of reboot. Any ideas? [ 2.392800] dwmac-sun8i 5020000.ethernet: IRQ eth_wake_irq not found [ 2.392834] dwmac-sun8i 5020000.ethernet: IRQ eth_lpi not found [ 2.393489] dwmac-sun8i 5020000.ethernet: PTP uses main clock [ 2.393545] dwmac-sun8i 5020000.ethernet: Current syscon value is not the default 58000 (expect 50000) [ 2.405541] usb 2-1: USB disconnect, device number 2 [ 2.501691] dwmac-sun8i 5020000.ethernet: No HW DMA feature register supported [ 2.501720] dwmac-sun8i 5020000.ethernet: RX Checksum Offload Engine supported [ 2.501728] dwmac-sun8i 5020000.ethernet: COE Type 2 [ 2.501738] dwmac-sun8i 5020000.ethernet: TX Checksum insertion supported [ 2.501747] dwmac-sun8i 5020000.ethernet: Normal descriptors [ 2.501755] dwmac-sun8i 5020000.ethernet: Chain mode enabled [ 2.677402] dwmac-sun8i 5020000.ethernet end0: renamed from eth0 [ 7.374514] dwmac-sun8i 5020000.ethernet end0: Register MEM_TYPE_PAGE_POOL RxQ-0 [ 7.380876] systemd[1]: Started systemd-rfkill.service - Load/Save RF Kill Switch Status. [ 7.422454] dwmac-sun8i 5020000.ethernet end0: PHY [stmmac-0:01] driver [RTL8211E Gigabit Ethernet] (irq=POLL) [ 7.422504] dwmac-sun8i 5020000.ethernet end0: No Safety Features support found [ 7.422518] dwmac-sun8i 5020000.ethernet end0: No MAC Management Counters available [ 7.422530] dwmac-sun8i 5020000.ethernet end0: PTP not supported by HW [ 7.423042] dwmac-sun8i 5020000.ethernet end0: configuring for phy/rgmii-id link mode [ 11.518341] dwmac-sun8i 5020000.ethernet end0: Link is Up - 1Gbps/Full - flow control off [ 16.296572] dwmac-sun8i 5020000.ethernet end0: Too many address, switching to promiscuous