Aleksey Vasenev

Same problem on my another board in latest build, sometime boot (30%), sometime not (70%): Armbian_community_24.8.0-trunk.314_Orangepi3-lts_bookworm_current_6.6.36_minimal.img.xz

armbianEnv.txt: verbosity=7 1.log

6.1.77 good 6.1.87 good 6.1.88 bad 6.1.89 bad 6.1.90 bad 6.1.92 bad 6.1.96 bad

From latest sources also not work Armbian-unofficial_24.8.0-trunk_Orangepizero_bookworm_legacy_6.1.96_minimal.img May be size problem? 6.1.92 size more than 8MiB. Older kernel size less than 8MiB. But this does not explain why 6.6 and 6.7 work despite the larger size.

Same problem on Orange Pi Zero: 6.1.53 work 6.6.31 work 6.1.92 stuck on "Starting kernel..."

Can't up ethernet link in some kernels. 6.1.92 work 6.6.16 don't work 6.6.31 don't work 6.7.4 don't work 6.7.12 don't work In dmesg last line missing when don't work: [ 11.875133] dwmac-sun8i 5020000.ethernet eth0: Register MEM_TYPE_PAGE_POOL RxQ-0 [ 12.125838] dwmac-sun8i 5020000.ethernet eth0: PHY [stmmac-0:01] driver [YT8531 Gigabit Ethernet] (irq=POLL) [ 12.125907] dwmac-sun8i 5020000.ethernet eth0: No Safety Features support found [ 12.125917] dwmac-sun8i 5020000.ethernet eth0: No MAC Management Counters available [ 12.125925] dwmac-sun8i 5020000.ethernet eth0: PTP not supported by HW [ 12.126603] dwmac-sun8i 5020000.ethernet eth0: configuring for phy/rgmii-id link mode [ 15.202402] dwmac-sun8i 5020000.ethernet eth0: Link is Up - 1Gbps/Full - flow control rx/tx But in very rare cases the link still goes up. There is also a remote second similar device, it works without problems. Incompatibility with router? The USB network card works without problems.