Flops

Anyway, as it turns out I didn't have "local access" enabled in the access point settings. LOL

When scanning the network via arp-scan it still writes (Unknown: locally administered).

Is there anything else I need to check?

And yes, that log I sent you is without the cable connected.

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever inet6 ::1/128 scope host noprefixroute valid_lft forever preferred_lft forever 2: end1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000 link/ether 2a:77:33:98:ba:5a brd ff:ff:ff:ff:ff:ff inet 192.168.0.108/24 brd 192.168.0.255 scope global dynamic noprefixroute end1 valid_lft 7145sec preferred_lft 7145sec inet6 fe80::8a87:d850:159c:a59e/64 scope link noprefixroute valid_lft forever preferred_lft forever This is what the ip a gave me when I plugged in the cable.

When I connected to cable and uart it was able to update and download packages. I will try to copy the log again today. And I'll also check ifconfig

Here are the notes after the command log

Could you tell me how to conveniently transfer logs to a text file, because the terminal floats when scrolling?

I tried rebooting the router. Nothing changed in the end. The router does not respond to ping, but the board works properly via uart. Please help

Suddenly after updating via armbian-config I lost ssh access and found the port closed. I rewrote the latest armbian version, stuck the sd card in, connected to ethernet cable via router and started up. The red and green lights were on as they should be and the internet cable was flashing green. Waited 3 minutes and checked the ports with nmap. And the port is closed again. Not responding to ping at all. I am still new to this topic. Please help and sorry if the translator translates crookedly.