Skip to content
View in the app

A better way to browse. Learn more.

Armbian Community Forums

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Wrong power supply. Board does not start

Featured Replies

Hi there,

 

a erroneously powered the Espressobin (V7) with my laptop power-supply [ i.e. 19V 2.31A ( right polarity i.e. + inside) ] ...

 

The EspressoBin now does not boot.

 

A green led lights-up for a moment and then nothing else.

 

Any suggestion ?

 

Thanks

 

You have wiped out your input voltage circuit. To be brutally sincere you've probably destroyed the board.

 

That being said, take a look at the schematics -

http://wiki.espressobin.net/tiki-index.php?page=Schematics

select your model ...

 

scroll down to page 14 and look at U9 - the regulator ... if all you did was wipe that out, you could replace it. You will need hot air soldering equipment and skills.

 

HOWEVER, it's my experience that when over voltage is applied to a regulator, many times it fails by passing the power rather than blocking it. There is a good chance that 19 volts was applied to many 1.8 and 3.3 v circuits. In that case your board is toast.

 

Mark it up to expensive education ... we've all done it. Most of us have plugged 12v into 5v boards that have no regulation. In that case the board is also toast.

  • Author
On 3/23/2020 at 6:46 PM, Technicavolous said:

You have wiped out your input voltage circuit. To be brutally sincere you've probably destroyed the board.

 

That being said, take a look at the schematics -

http://wiki.espressobin.net/tiki-index.php?page=Schematics

select your model ...

 

scroll down to page 14 and look at U9 - the regulator ... if all you did was wipe that out, you could replace it. You will need hot air soldering equipment and skills.

 

HOWEVER, it's my experience that when over voltage is applied to a regulator, many times it fails by passing the power rather than blocking it. There is a good chance that 19 volts was applied to many 1.8 and 3.3 v circuits. In that case your board is toast.

 

Mark it up to expensive education ... we've all done it. Most of us have plugged 12v into 5v boards that have no regulation. In that case the board is also toast.

Thanks a lot ... I'll try to see if I was lucky ... otherwise I'll go for "expensive education" :D

Guest
This topic is now closed to further replies.

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.