i am not sure which sbc- this udoo is: which version of udoo

dear community, 

i am not sure which sbc- this udoo is: which version of udoo 

well i guess -that this is a Udoo Quad Makerboard Rev. D.
question: can i connect this to a SATA Board !?

Note i want to build up a NAS/ Samba server.

can i do that with this UDoo quad

found the following specs

CPU NXP i.MX 6 ARM Cortex-A9 Quad core 1GHz
GPU Vivante GC 2000 + Vivante GC 355 + Vivante GC 320
Integrated accelerators for 2D, OpenGL® ES2.0 3D and OpenVG™
Atmel SAM3X8E ARM Cortex-M3 CPU (same as Arduino Due)
RAM DDR3 1GB
76 fully available GPIO: 62 digital + 14 digital/analog
Arduino-compatible R3 1.0 pinout
HDMI and LVDS + Touch
2 Micro USB (1 OTG type a+b)
2 USB type A (x2) and 1 USB connector (requires a specific wire)
Analog Audio and Mic
CSI Camera Connection
on board Micro SD card reader (boot device)
Input Voltage (recommended) 6-15 V
Ethernet RJ45 (10/100/1000 MBit)
WiFi Module
SATA
are they still correct - and do the de

the question is  - which operating-system should i choose here!?