Hi,

By installing armbian jessie on my Orange pi plus 2 E, after login,I have a choice to change the resolution of screen( to 1920x1080),but unfortunately I have no succes.

 

Can you please tel me how can I do that?

 

Thanks

           Sadegh 

- you have monitor via HDMI?

- did you reboot?

- what happened?

-no.it is LG Flatron E22411S-BN

-Yes

-the same thing again. I can choose for No Change resolution,but I don't know how can I change it,when is installation is completed.

If resolution remain unchanged, there is a possibility that your system is corrupted / read only due to failed SD card.

Ok. Thanks. I go try again. This time with an another SD card.

h3disp -m 1080p60 -d

 

this works on OPi 2 Plus

 

tried this as well in /boot/armbianEnv.txt

 

verbosity=7
console=both
machid=1029
bootm_boot_mode=sec
disp_mem_reserves=on
rootdev=UUID=138db2fa-ed4a-4003-8f07-0bce591c3ec5
rootfstype=ext4
#disp_mode=2160p30
disp_mode "1920x1080p60"
overlay_prefix=sun8i-h3
overlays=w1-gpio uart1 i2c0 spi-spidev
param_w1_pin=PA20
param_w1_pin_int_pullup=1
param_uart1_rtscts=1
param_spidev_spi_bus=0
overlays=sun8i-h3-spi0-spidev
 

Thanks jbird1!