Vega Sun

Hi there, I'm using the latest version of armbian to run the linuxptp for the ieee1588v2 clock. When I check the timestamp status, the 1Gbps port which is the RTL8122 is no problem, but the 2.5G ports RTL8125BG are only supporting the software timestamp. However, when I checked the Realtek website, it says that the 8125BG also supports the IEEE1588 clock. I tried to install the driver, but it did not work. As a beginner in Linux, I probably don't have the knowledge to compile drivers, in this case I sincerely hope that armbian could officially support the hw ptp timestamp in 8125 NIC. Thank you very much! nanopi-r6s:~:# ethtool -T end0 Time stamping parameters for end0: Capabilities: software-transmit software-receive software-system-clock PTP Hardware Clock: none Hardware Transmit Timestamp Modes: none Hardware Receive Filter Modes: none nanopi-r6s:~:# ethtool -T end1 Time stamping parameters for end1: Capabilities: hardware-transmit software-transmit hardware-receive software-receive software-system-clock hardware-raw-clock PTP Hardware Clock: 0 Hardware Transmit Timestamp Modes: off on Hardware Receive Filter Modes: none all ptpv1-l4-event ptpv1-l4-sync ptpv1-l4-delay-req ptpv2-l4-event ptpv2-l4-sync ptpv2-l4-delay-req ptpv2-event ptpv2-sync ptpv2-delay-req