geoW

VM
removed Proxmox armbian-upgrade reboot VM installed Proxmox (now without error messages) Great!!! So nice to get a little test/learning Proxmox instance rapidly, Than You.
 

... problem is elsewhere. This is running:
 
sudo dpkg-reconfigure tzdata  
in CLI (Armbian Noble), choosing region Atlantic, then:
 

I guess this should do:

25.2.3 build fine after upgrade though I had to hold rpi-eeprom, raspi-firmware and raspberrypi-sys-mods
 
Also still getting the Method gave a blank filename apt error

I confirm, here it  is failing setting up openssh service, it starts rebooting after root autologin prompt, tested on rpi5.

I finally successfully updated Nextcloud to version 31.0.10 on my Odroid N2+ 😅
 
Despite all official information, an update is possible on a system running nextcloud installed via the script !
It is not necessary to buy a new hardware just to run nextcloud on your Armbian SBC in order to get the update.
 
I did the following:
Updated nextcloudpi to version 1.55.4 which was never released but just tagged on github Nextcloudpi tagged page on github via the ncp-config menu system (Updates/nc-update) Updated nextcloud to version 31.0.10, again, via the menu system (Updates/nc-update-nextcloud version 31.0.10) I don't really know why this information is not readily available on the nextcloudpi github page nor anywhere else I looked.
 
Have fun
Norbert

The following is documented:
 
But nobody seems to read the docs.😪
Raspberry Pi

yes