Hello,

When I comment device via USB 3.0 I see it:

 

ender3@ender3:~$ lsusb
Bus 005 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 004 Device 002: ID 1d50:614e OpenMoko, Inc.
Bus 004 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub

 

However with pins GND, DP1, DM1, +5V

 

Bus 005 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 004 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub

 

 

See Layout / USB2.0 - https://wiki.friendlyarm.com/wiki/index.php/NanoPi_NEO3

 

Any ideas how I should activate these pins? Want to connect 3d printer and endoscope OTG camera that works with RPi, so should be matter of drivers. Testing on printer now.

 

Also, if it is not supported, may I use simple USB 2.0 hub to connect to USB 3.0 port WiFI card, 3d printer and OTG endoscope camera? Prefer to activate these pins if I may to choose : )

Edited December 5, 20205 yr by Piecho

Anybody could help me please?

Same problem here.

Changed OTG to "host" in device tree in armbian-config but still doesn't recognise connected USB device. Any ideas?

same here 2022 any updates on this ?