Hello everybody,

 

im experiencing a similar problem.

Sometimes my WD RED 12 TB HDD is not recognized in that slot its in, when i change it to any other it works again.

 

Nevertheless it seems this problem doesnt only apply to one specific slot, but is changing from time to time.

 

EDIT: The LED of that slot doesnt turn on, yet the drive starts and runs

 

Do anybody experience the same problem, or know any help?

 

Thank you in advance.

 

Best Regards.

@Vin I think you issue might not be related to the thread.

Most likely some bad physical connection, please check by opening the back panel that the HDD is well inserted in the SATA backplane connector.

Am 28.1.2021 um 08:24 schrieb gprovost:

@Vin I think you issue might not be related to the thread.

Most likely some bad physical connection, please check by opening the back panel that the HDD is well inserted in the SATA backplane connector.

 

SATA Ports are firm, also connection to the HDDs are proper.

 

Just restarted and did a fresh install of the new februar update, two out of three HDDs are not recognized anymore, even though they were recognized before and have not been unplugged.

Which HDD (on which SATA port) are not recognized anymore ?

Have you tried plugging the unrecognized ones in another slot just to check if it's an issue specific to one or more of the slots.

 

 

Both, the affected HDDs and Ports are random

 

Plugging them in another Port solves the problem, but they can get affected again at a later point, plugging them back to the original ports solves the problem.

Please provide the link generated by command armbianmonitor -u

http://ix.io/2Pty