USB serial not working with Bullseye Minimal/Regular CLI version (stops working after initial setup)

Hi,

I've installed minimal cli version and it restarts when connected to PC via on-board USB-C connector. Board hangs after:

[  OK  ] Reached target Hardware activated USB gadget.

Host computer does:

[ 4881.959467] usb 1-5: new high-speed USB device number 47 using xhci_hcd
[ 4882.140301] usb 1-5: New USB device found, idVendor=0525, idProduct=a4a6, bcdDevice= 5.15
[ 4882.140315] usb 1-5: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[ 4882.140322] usb 1-5: Product: Gadget Serial v2.4
[ 4882.140327] usb 1-5: Manufacturer: Linux 5.15.80-rockchip64 with ff580000.usb
[ 4883.572730] usb 1-5: USB disconnect, device number 47
[ 4884.079492] usb 1-5: new high-speed USB device number 48 using xhci_hcd
[ 4884.229424] usb 1-5: device descriptor read/64, error -71
[ 4884.499520] usb 1-5: device descriptor read/64, error -71
[ 4884.769501] usb 1-5: new high-speed USB device number 49 using xhci_hcd
[ 4884.919510] usb 1-5: device descriptor read/64, error -71
[ 4885.189426] usb 1-5: device descriptor read/64, error -71
[ 4885.309571] usb usb1-port5: attempt power cycle
[ 4885.779457] usb 1-5: new high-speed USB device number 50 using xhci_hcd
[ 4885.779556] usb 1-5: Device not responding to setup address.
[ 4885.999459] usb 1-5: Device not responding to setup address.
[ 4886.219537] usb 1-5: device not accepting address 50, error -71
[ 4886.369509] usb 1-5: new high-speed USB device number 51 using xhci_hcd
[ 4886.369639] usb 1-5: Device not responding to setup address.
[ 4886.589578] usb 1-5: Device not responding to setup address.
[ 4886.809467] usb 1-5: device not accepting address 51, error -71
[ 4886.809571] usb usb1-port5: unable to enumerate USB device

On regular CLI version it seems to work for now. Or in fact it stops working after initial setup!

Edited February 9, 20233 yr by MrJake222
new info