Hi Community,

 

i was upgrading from kernel 5.10.160 to the new 6.8.2-edge for Rock Pi 5b / rk3588.

Now i missing many DTB overlays 😞 which where aviable in 5.10.160
 

I need UART3_M1, UART7_M1

What is with Kernel 6.8.2 the right way to export GPIOs and set there direction ?

This does not work longer

cd /sys/class/gpio
echo 157 > export

 

Thanks a lot for your help 🙂

Edited April 3, 20242 yr by ReneHegewald

May not even work yet. mainline is still bleeding edge and is missing features.

If you need full functionality keep using legacy kernel.

Has anyone tried sata with mainline? Is this overlay available?

https://wiki.radxa.com/Rock5/guide/sata

 

 

Hi Werner,

 

ok 😕 ...
 

Hope will change in the Future ...

Best regards,
René

@q-bert  if work with Sata1 from Kernel "6.8.2-edge-rockchip-rk3588" .. works fine

@ReneHegewald thanks

How did you activate it (change from pci to sata)?

Edited April 3, 20242 yr by q-bert

i use armbian-config tool 🙂 this makes a great job 

@werner it is possible to express the wish ... to integrate GPIO & the overlays ... please

Sure but do not expect this to happen (soon) without funding.

@ReneHegewald I'll add a couple of points to what @Werner has already mentioned.

The board you are using RockPi 5B is not supported by Armbian.  It is Community supported.  That means Armbian doesn't have any resources that work on this board.  All support for the board is done by community members like you.  There generally is little that happens to community supported boards.  Usually someone will submit some work to get the board initially setup and then shortly after disappear and nothing happens to the board again until it stops building at all and then it gets dropped.  Unfortunately this is the reality of support for these boards.  You are using software for free and it takes significant resources (both money and time) to make a board work well.  There are very few people that are willing to donate a hundred hours of time to work on getting a board fully supported and maintain it over time with no compensation.  Unfortunately the manufactures of these boards take advantage of the open source community.  They in house initially do some minimum work to get something running, then once released move on to their next board and don't support the software and hope the open source community does it for free. 

The best thing you can do, is build up your skills and contribute back to the community in exchange for the free software you are using.

11 hours ago, ReneHegewald said:

if work with Sata1 from Kernel "6.8.2-edge-rockchip-rk3588" .. works fine

 

There are rk3588 edge overlays available for SATA

 

https://github.com/armbian/build/tree/main/patch/kernel/rockchip-rk3588-edge/overlay

@lanefu Thanks a lot 🙂 ...
The last open Question .. with the Edge Kernel, what is the right way to export the GPIO's 

cd /sys/class/gpio 
echo 157 > export

does not work 🙂

That should be resolved as of this PR

 

https://github.com/armbian/build/pull/6580