Hi all!

After success image building I have problem at boot [Armbian_5.37_Lime2_Debian_jessie_default_3.4.113]

Boot stoped after line '<6>axp20_ldo2: 1800 <--> 3300 mV at 3000 mV'

PSU and board work fine, what is the problem?

 

Regards,

 

boot log

========HV Inital ===================
<3>tkey_fetch_sysconfig_para: tkey_unused.
hv_keypad_init: after fetch_sysconfig_para:  normal_i2c: 0x0. normal_i2c[1]: 0x0
<3>sunxi-rtc sunxi-rtc: Warning: RTC time is wrong!
<6>sunxi-rtc sunxi-rtc: rtc core: registered rtc as rtc0
<6>i2c /dev entries driver
config i2c gpio with gpio_config api
<6>axp_mfd 0-0034: AXP (CHIP ID: 0x41) detected
<6>axp_mfd 0-0034: AXP internal temperature monitoring enabled
<4>i2c i2c-0: Invalid probe address 0x00
<6>I2C: i2c-0: AW16XX I2C adapter
config i2c gpio with gpio_config api
<4>i2c i2c-1: Invalid probe address 0x00
<6>I2C: i2c-1: AW16XX I2C adapter
config i2c gpio with gpio_config api
<4>i2c i2c-2: Invalid probe address 0x00
<6>I2C: i2c-2: AW16XX I2C adapter
<5>cedar: failed to allocate memory buffer
[tt]----- avs_dev driver load... ----
[tt]-----      register iomem      ----
Cannot reserve region for ccmu
[tt]--- avs_dev driver load ok!! -----
[ace_drv] start!!!
[ace_drv] init end!!!
[pa_drv] start!!!
[pa_drv] init end!!!
<6>axp20_ldo1: 1300 mV
<6>axp20_ldo2: 1800 <--> 3300 mV at 3000 mV

 

 

Mainline Linux 4.13.16 for Limo2 work fine.

Linux 3.4.x not supported more in Armbian?

 

Regards,

15 hours ago, alexparser said:

PSU and board work fine, what is the problem?

 

Need to be investigated. 

 

8 minutes ago, alexparser said:

Linux 3.4.x not supported more in Armbian?

If you use the one from the download section, then it's supported. If you build on your own, check/get involved in https://forum.armbian.com/forum/20-development/ Just after the last release we moved up with u-boot and things might be partially broken at the moment.

Hi, if it's the same problem I had, you can try this :