Beginners

I have a Waveshare 2.8 A TFT LCD (https://www.waveshare.com/wiki/2.8inch_RPi_LCD_(A)) and I used it with the orange pi zero LTS board using the instructions given here: I used Armbian_5.90_Orangepizero_Ubuntu_bionic_next_4.19.57.img as the OS, downloaded from the Armbian download page archives. It worked on the first try, and displayed the console on the LCD screen. I was able to log into the Orangepi Zero board from the serial port (ttyS0) connected to the PC, from ssh in Putty on the same PC, and also from the console shown in the LCD (tty1) using a keyboard attached directly to the orangepi zero. I started following other tutorials to try and …

System: Armbian_22.08.1_Nanopim4v2_bullseye_current_5.15.63.img.xz 4x SATA HAT (https://tinyurl.com/2hovcx2g) OMV6 Problem: Making changes with OMV6 GUI like adding a share folder, sometime syslog report what looks to me like a SATA error. Spinning HDD start 'clicking' (seeking) and file system unmounts Soft reboot does not solve the problem...I have disconnect the power supply and boot again. The NanopiM4V2 and 4xspinning HDD are powered with a lab bench top power supply 12VDC / 15Amp...(just to rule out the power supply side) I am reporting this here since the log reports the SATA error from the Kernel and I don…

I tried to build an bridged AP so that I can reach the Internet from a WiFi net spawned from the BananaPiPro. By this I followed the procedure from armbian-config (config.network.sh). After install the AP is shown in the login screen: WiFi AP: SSID: (BPi), channel 7 (2442 MHz), width: 20 MHz, center1: 2442 MHz When I try to connect from my mobile phone it either says "connecting without Internet". The output in syslog is then: 026-07-06T12:35:02.645970+02:00 bananapipro hostapd: wlan0: STA 22:50:7b:ac:e3:2e IEEE 802.11: associated 2026-07-06T12:35:02.690671+02:00 bananapipro hostapd: wlan0: STA 22:50:7b:ac:e3:2e RADIUS: …